ATAG · iC, iS and iR range
108Pressure below 0.5 bar; filling required
This code applies to iC Economiser, iC Combination, iS System, iR Regular. Fault codes narrow down the likely problem, but they do not replace a model-specific diagnosis.
What you can safely check
- Check the pressure gauge with the system cold.
- If it is below the range stated in the boiler manual, repressurise only by following that model's user instructions.
- Stop and book an engineer if pressure drops again, rises excessively, or there is a visible leak.
How an engineer may fix it
Check for leaks, trapped air, the pressure sensor, pump and expansion vessel; repair the underlying fault before recommissioning.
Manufacturer source: ATAG — Boiler Troubleshooting (2019 & newer i-range). Checked 15 August 2026. The appliance manual and an engineer’s on-site diagnosis take precedence. Never remove the boiler case yourself.